Yamaha FX10X 2008, Руководство по обслуживанию

Страница: 63 / 411

2-46
INSP
ADJ
HEADLIGHT BEAM ADJUSTMENT/BATTERY INSPECTION
HEADLIGHT BEAM ADJUSTMENT
1. Place the snowmobile on a level surface.
2. Place the snowmobile in front of a wall at the
recommended distance
D
. Refer to the table
below.
3. Measure the distance
H
from the floor to the
center of the headlight and place a mark on the
wall at that height.
4. With a person sitting on the snowmobile, apply
the parking brake, start the engine and let it idle.
5. Switch on the headlight high beam and check
the height of the projected beam on the wall.
The projection should be at the position marked
in step 3 or 1/2° lower (set range
S
).
D
: Distance
H
: Height
S
: Set range
D
3.0 m (10 ft) 7.6 m (25 ft)
S
26 mm (1.0 in) 66 mm (2.6 in)
6. Adjust:
• Headlight beam (vertically)
Adjustment steps:
• Remove the shroud.
Refer to “COVERS” in CHAPTER 3.
• Turn the adjusting screw
1
in direction
a
or
b
to adjust the headlight beams.
BATTERY INSPECTION
WARNING
Batteries generate explosive hydrogen gas and
contain electrolyte which is made of poisonous
and highly caustic sulfuric acid. Therefore,
always follow these preventive measures:
• Wear protective eye gear when handling or
working near batteries.
• Charge batteries in a well-ventilated area.
• Keep batteries away from fire, sparks or open
flames (e.g., welding equipment, lighted ciga-
rettes).
• DO NOT SMOKE when charging or handling
batteries.
• KEEP BATTERIES AND ELECTROLYTE OUT
OF REACH OF CHILDREN.
• Avoid bodily contact with electrolyte as it can
cause severe burns or permanent eye injury.
Direction
a
Headlight beam is raised.
Direction
b
Headlight beam is lowered.
1
b a a b