Yamaha FX10X 2008, Руководство по обслуживанию

Страница: 299 / 411

7-23
FI
FUEL INJECTION SYSTEM
Fault code No. 44 Symptom
Error is detected while reading or writing on EEPROM (CO adjustment
value).
Diagnostic No. 60 (EEPROM improper cylinder indication)
Order Item/components and probable cause Check or maintenance job Reinstatement
method
1 Malfunction in ECU. Execute the diagnostic mode (code No. 60).
1. Check the faulty cylinder. (If multiple cylinders
are defective, the display alternates every 2
seconds.)
2. Readjust the CO of the displayed cylinder.
Replace ECU if defective.
Setting the
engine stop
switch to “RUN”
and turning the
main switch on.
Fault code No. 46 Symptom Power supply to the ECU is not normal.
Diagnostic code No. – –
Order Item/components and probable cause Check or maintenance job Reinstatement
method
1 Connections
Wire harness ECU coupler
Check the coupler for any pins that may have
pulled out.
Check the locking condition of the coupler.
If there is a malfunction, repair it and connect the
coupler securely. Starting the
engine and
operating it at
idle.
2 Faulty battery. Replace or charge the battery.
Refer to “BATTERY INSPECTION” in CHAPTER
2.
3 Malfunction in rectifier/regulator. Replace if defective.
Refer to “CHARGING SYSTEM” in CHAPTER 8.
4 Open or short circuit in wire harness. Repair or replace if there is an open or short cir-
cuit.
Between the battery and main fuse.
Red – Red
Between the main fuse and ignition fuse.
Red – Red
Between the ignition fuse and main switch cou-
pler.
Red/Yellow – Red/Yellow
Between the main switch coupler and engine stop
switch coupler.
Brown – Brown
Between the engine stop switch coupler and ECU
coupler.
Red/White – Red/White
Fault code No. 50 Symptom
Faulty ECU memory. (When this malfunction is detected in the ECU, the
fault code number might not appear on the meter.)
Diagnostic code No. – –
Order Item/components and probable cause Check or maintenance job Reinstatement
method
1 Malfunction in ECU. Replace the ECU. Setting the
engine stop
switch to “RUN”
and turning the
main switch on.