Yamaha FJR1300A(D), Руководство по обслуживанию

Страница: 135 / 662

CABLE ROUTING
2-64
1. Right headlight lead
2. Right auxiliary light lead
3. Relay unit lead
4. Main relay
5. Headlight relay (dimmer) lead
6. Left headlight lead
7. Left auxiliary light lead
8. Windshield drive unit relay (down) lead
9. Left radiator fan motor lead
10. Windshield drive unit relay (up) lead
11. Accessory box solenoid sub-lead coupler
12. Auxiliary DC jack coupler
13. Front left turn signal light coupler
14. Wire harness
15. Windshield drive unit coupler
16. Windshield drive unit sub-lead coupler
17. Left handlebar switch couplers
18. Air temperature sensor lead
19. Right handlebar switch couplers
20. Meter assembly lead
21. Front brake light switch coupler
22. Grip warmer couplers
23. Clutch switch coupler
A. Towards the front of the vehicle
B. Make sure that the handlebar switch leads, grip
warmer leads, front brake light switch lead, and
clutch switch lead are not resting on top of the relay
bracket.
C. Secure the plastic band by inserting the projection
on the band into the hole in the relay bracket, and
then fasten the handlebar switch leads, grip
warmer leads, front brake light switch lead, and
clutch switch lead with the band. Face the end of
the plastic band outward. Do not cut off the excess
end of the plastic band.
D. Insert the projection on the wire harness holder
completely into the hole in the relay bracket.
E. From electrical components tray
F. Route the relay unit lead to the rear of the
headlight beam adjusting knob shaft.
G. Red tape
H. Route the headlight relay (dimmer) lead to the front
of the headlight beam adjusting knob shaft.
I. Blue tape
J. Route the relay leads, meter assembly lead, and
leads (to electrical components board) in the order
listed from top to bottom.
K. Fasten the wire harness at the white tape on both
portions of the harness with a plastic locking tie.
Position the end of the plastic locking tie under the
meter assembly, facing inward. Do not cut off the
excess end of the plastic locking tie.
L. Route the wire harness between the relay bracket
and windshield drive unit bracket.
M. Route the windshield drive unit sub-lead to the
front of the windshield cable.
N. Insert the projection on the windshield drive unit
sub-lead coupler completely into the hole in the
electrical components board.
O. Insert the projection on left handlebar switch
coupler completely into the hole in the electrical
components board.
P. Insert the projection on right handlebar switch
coupler completely into the hole in the electrical
components board.
Q. Secure the holder by inserting the projection on
the holder into the hole in the electrical
components board, and then fasten the handlebar
switch leads, grip warmer leads, front brake light
switch lead, clutch switch lead, and meter
assembly lead with the holder. Face the catch of
the holder upward.
R. Insert the projection on the front brake light switch
coupler completely into the hole in the electrical
components board.
S. Insert the projection on the clutch switch coupler
completely into the hole in the electrical
components board.
T. Insert the projection on the wire harness holder
completely into the hole in the electrical
components board.