Yamaha FJR1300, Руководство по обслуживанию

Страница: 306 / 572

4 - 110
CHAS
SHAFT DRIVE
Example:
If the final drive housing is marked “51”, the
ring gear bearing housing is marked “35”, the
ring gear is marked “– 05”, and “
f
” is 13.00:
B = (45 + 51/100) + (3 + 35/100) –
[(35.40 – 5/100) + 13]
= (45 + 0.51) + (3 + 0.35) –
[(35.40 – 0.05) + 13]
= 45.51 + 3.35 – [(35.40 – 0.05) + 13]
= 48.86 – [35.35 + 13]
= 48.86 – 48.35
= 0.51
Therefore, the calculated ring gear shim thick-
ness is 0.51 mm (0.02 in).
Shim sizes are supplied in the following thick-
nesses.
Since the ring gear shims are only available in
0.10 mm (0.004 in) increments, round off the
hundredths digit.
In the example above, the calculated ring gear
shim thickness is 0.51 mm (0.02 in). The chart
instructs you to round off the 1 to 0. Thus, you
should use a 0.50 mm (0.02 in) ring gear shim.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Ring gear shims
Thickness (mm) 0.25 0.30 0.40 0.50
Hundredth Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10