Yamaha A3000, Руководство по модернизации

Страница: 27 / 50

Changes in PLAY MODE
27
Chapter 2
Chapter 2 Upgrade Reference
PLAY - CONTROL -
PgmLFO2
[Program-LFO Setup 2]
• Knob 2 sets the LFO’s initial phase. If
Sync = MIDI
, this phase will coincide with the
start of the MIDI-clocked note length. If
Sync = manual
, this phase is produced by
LFO reset. Note that reset conditions themselves are set up by Knobs 3 and 4 as
follows.
• Knob 3 sets the MIDI channel that can be used to reset the LFO. You can set the value
to
off
(resets disabled);
audition
(reset generated by pressing the AUDITION key);
1
to
16
(reset generated by note-on events over the specified MIDI channel only), or
Bch
(reset generated by note-on events received over the basic receive channel).
• Knob 4 sets the specific note that generates the reset. This setting is available only if
Knob 3 is set to
1
to
16
or to
Bch
. You can select any single note on the keyboard (
C-
2
to
G8
), or you can select
all
notes. Reset is generated when a note-on event for the
specified note is received over the MIDI channel selected by Knob 3.
• It is recommended that you use the note you select here only as a “reset switch,” and
that you avoid mapping any samples to it. Although it is possible to use this note both
for reset and playback purposes, the playback timing may be noticeably delayed.