Yamaha 2007 XP500, Руководство по обслуживанию

Страница: 328 / 450

ELECTRIC STARTING SYSTEM
8-13
EAS27190
TROUBLESHOOTING
The starter motor fails to turn.
NOTE:
Before troubleshooting, remove the following part(s):
1.Front cowling
2.Leg shield
3.Fotrest board
4.Fuel tank
1. Check the fuses.
(Main and ignition)
Refer to
“ CHECKING THE FUSES ” on
page 8-106.
NG
→
Replace the fuse(s).
OK
↓
2. Check the battery.
Refer to “ CHECKING AND CHARG-
ING THE BATTERY ” on page 8-107.
NG
→
● Clean the battery terminals.
● Recharge or replace the battery.
OK
↓
3. Check the starter motor operation.
Refer to “ CHECKING THE STARTER
MOTOR OPERATION ” on page 8-115.
OK
→
Starter motor is OK. Perform the electric starter
system trouble shooting, starting with step 5.
NG
↓
4. Check the starter motor.
Refer to “ CHECKING THE STARTER
MOTOR ” on page 5-37.
NG
→
Repair or replace the starter motor.
OK
↓
5. Check the starting circuit cut-off relay
1.
Refer to
“ CHECKING THE RELAYS ”
on page 8-110.
NG
→
Replace the starting circuit cut-off relay 1.
OK
↓
6. Check the starting circuit cut-off relay
1 (Diode).
Refer to
“ CHECKING THE RELAYS ”
on page 8-110.
NG
→
Replace the starting circuit cut-off relay 1.
OK
↓
7. Check the starting circuit cut-off relay
2 (XP500A).
Refer to
“ CHECKING THE RELAYS ”
on page 8-110.
NG
→
Replace the starting circuit cut-off relay 2
(XP500A).
OK
↓
8. Check the starter relay.
Refer to “ CHECKING THE RELAYS ”
on page 8-110.
NG
→
Replace the starter relay.
OK
↓
9. Check the main switch.
Refer to “ CHECKING THE
SWITCHES ” on page 8-101.
NG
→
Replace the main switch.
OK
↓
10. Check the engine stop switch.
Refer to “ CHECKING THE
SWITCHES ” on page 8-101.
NG
→
Replace the right handlebar switch.