Yamaha 2007 XP500, Руководство по обслуживанию, Страница: 26 / 450

FEATURES
1-17
engine stop switch is set to “ ON ” .
2. Disconnect the V-belt replacement reset cou-
pler “ 1 ” for two to ten seconds.
3. And then, connect the V-belt replacement re-
set coupler, the V-belt replacement indicator
will come on for 1.4 seconds. And the V-belt
replacement indicator will go off.
NOTE:
If the V-belt is replaced before the V-belt re-
placement indicator comes on (i.e. before the
V-belt replacement interval has been reached),
the indicator must be reset after the V-belt re-
placement for the next periodic V-belt replace-
ment to be indicated at the correct time.
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the
multi-function display will indicate a two-digit er-
ror code.
If the multi-function display indicates such an er-
ror code, note the code number, and then check
the vehicle. Refer to
“ FUEL INJECTION SYS-
TEM ” on page 8-33, “ IMMOBILIZER SYSTEM ”
on page 8-57, “ ABS (ANTI-LOCK BRAKE SYS-
TEM) (XP500A) ” on page 8-65.
CAUTION:
ECA11790
If the multi-function display indicates an er-
ror code, the vehicle should be checked as
soon as possible in order to avoid engine
damage.
Clock mode
To set the clock:
1. Push the “ SELECT ” button and “ RESET ” but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
“ RESET ” button to set the hours.
3. Push the “ SELECT ” button, and the minute
digits will start flashing.
4. Push the “ RESET ” button to set the minutes.
5. Push the “ SELECT ” button and then release
it to start the clock.