Yale MPB040-E, Руководство пользователя

Страница: 61 / 130

Table 2. Charger LEDs
Indicator Color Function
Power On Red Illuminates continuously
when AC power is present.
Abnormal
Shutdown
Red Flashes if abnormal shut-
down has occurred.
Detection
Error
Red Illuminates continuously
when battery is not con-
nected to charger or bat-
tery voltage is less than
2V.
Charging Yellow Charge status indicator -
flashes during charging cy-
cle.
Charged Green Illuminates continuously
when battery is fully
charged.
Charging
CAUTION
The charger comes factory set to charge mode 2
and must be changed if using batteries not speci-
fied for charger mode 2. Using an improper
charger mode for your battery pack may cause se-
vere damage to batteries or charger. Refer to
Charger Mode/Battery Type Selection (DPI Gen II
Models) or Charger Mode/Battery Type Selection
(DPI Gen III Models) in this section to verify the
proper mode setting for your battery pack.
Plugging the charger to the 120 volt AC outlet will be-
gin the start up cycle. Approximately three seconds
after connection to the AC power, all five LEDs on the
top of the charger will illuminate and flash two times.
This indicates the charger is set to charge U1800 type
batteries. Following the start up flashing of the LEDs,
the red, POWER ON, LED will illuminate to indicate
AC power is applied to the charger and will begin the
charging cycle.
The charger uses a 5-step charging process:
1. Pre Qualification Test. During this step, the yel-
low, CHARGING, LED will flash on and off every
two seconds. The charger is checking for faults
prior to the start of charging. Depending on the
condition and state of charge of the batteries, this
step can take from 45 seconds up to 5 hours.
2. Regulating Current. During this step, the charger
will be regulating current to the batteries and will
be operating at full rated output. The yellow,
CHARGING, LED will be constantly illuminated
during this step.
3. Regulating Voltage. During this step, the charger
will be regulating voltage to the batteries. The yel-
low, CHARGING, LED will remain illuminated.
When the batteries have reached 80 to 90 per-
cent of full charge, the yellow, CHARGING, and
the green, CHARGED, LEDs will be illuminated.
4. Charge Complete. During this step, the green,
CHARGED, LED will remain illuminated. AC
power can now be disconnected from the charger.
5. Recycle Stage. If the charger remains connected
to power for 28 days, a completely new charge
cycle will begin to keep batteries fully charged
during long periods of not being used.
NOTE: If the charger noted an abnormal charge con-
dition during the charging, the charger will attempt to
shutdown and will flash one or all three of the red
LEDs on the top of the charger. If this condition oc-
curs, see Troubleshooting (DPI Chargers), Error
Modes in this section.
2200 YRM 1007
Battery Charger (Accusense by DPI
®
)
37