18
Keyfob remote control accessory
Programming
Learn in the keyfob as follows:
1
Enter the ‘D/-‘ menu and select the
‘Add Device’ sub menu.
2
Press the Arm button on the keyfob remote
when prompted.
3
After you have assigned a zone number for the
keyfob remote, you are presented with a
choice:
• ‘Medical Emg’: Control unit dials a medical
emergency alarm when the Panic button on the
keyfob remote is pressed; or
• ‘Personal Att’: Control unit dials a personal
attack alarm when the Panic button is pressed.
4
After making your selection, the display will
show the successfully installed device.
5
Press OK.
• The Panic button has to be pressed for more
than 5 seconds to operate. This is a safety
feature to stop accidental operation.
• If programmed as a Personal Attack alarm, an
alarm started by the Panic button cannot be
silenced with the keyfob remote, only with the
control unit. This is a safety feature to stop any
potential attacker disarming the system after a
Personal Attack alarm has started.
Using
The system is armed by pressing the Arm or
Home button for at least 1 second (this delay
feature prevents accidental operation).
The system is disarmed by pressing the Disarm
button in the same way.
The switch at the side prevents the keyfob
from transmitting accidentally.
• The keyfob can also be used to answer an
incoming telephone call by pressing the Disarm
button twice for 1 second with a pause
between and then to close the call by pressing
the Disarm button again for 1 second.
• When arming the system in ‘home’ mode using
the keyfob remote, the system will arm and
disarm instantly without an exit or entry
countdown.
Keypad remote control accessory
Programming
1
Enter the ‘D/-‘ menu and select the
‘Add Device’ sub menu.
2
When prompted by the control unit enter 0000
on the keypad then press TEST. The ‘Tx’ LED
will flash showing that the keypad is in program
mode.
3
Press TEST then 1 on the keypad. The keypad
and the control unit will beep.
4
After you have assigned a zone to the keypad,
the display will show the successfully installed
device.
5
Press OK on the control unit.
6
Press Off twice on the keypad to exit program
mode, Tx LED will stop flashing.
• The keypad will beep every 30 seconds if the
tamper switch is open. Please ensure tamper
switch closes when mounting.
Changing PIN number
1
Put the keypad into programming mode by
entering the factory set code 0000 and pressing
TEST.
2
Enter 0000 then press CLR.
3
Enter your new 4 digit code then press PROG.
The keypad will beep in response.
4
Press OFF twice to exit programming mode.
• It is advisable to use the same PIN code as the
control unit, but it can be different.
Using
To arm the system:
Enter your PIN code and press Arm.
To disarm the system:
Enter your PIN code and press Off.
To home arm the system:
Enter your PIN code and press Home.
Adding accessories
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
Downloaded from www.ukpanels.com