13
Arming the system
Full arming
1
Enter your PIN code and press OK.
2
Arm and Home can be selected by using the
arrow keys, select ‘Arm’.
3
Press OK. The exit delay is displayed and
counts down from the default setting of 10
seconds. The control unit beeps (unless exit
sound has been switched off).
4
When the time is up, the control unit sounds a
long beep. ‘Alarm On’ is displayed and the
system is armed.
• The siren will beep once (if siren confirm has
been switched on), and the strobe will flash
once after the Exit Delay has expired.
Home arming
1
Enter your PIN code and press OK.
• You have a silent exit period in which to vacate
the armed area. This exit period is the same as
used when fully arming.
2
Press
▼
to move the cursor down to select
Home.
3
Press OK.
• You can also put the system into the home
mode by using the keypad or keyfob accessory.
Stopping the exit delay
Do this by disarming the system.
1
Press
a
.
2
Enter the PIN code.
3
Press OK.
’Alarm Off’ will be displayed and the system
returns to disarmed mode.
Disarming the system
1
Enter your pin code.
2
Press OK. The control unit will sound 2 short
beeps and disarm.
• The siren will beep twice (If siren confirm has
been switched on) and the strobe will flash
from side to side after the system has been
disarmed.
Alarm activation
If a sensor is triggered when armed, or if an
entry period is left to expire, the control unit will
activate the alarm immediately, while if a Home
Omit sensor is triggered, the control unit will not
respond if in home mode.
If a 24-hour alarm, fire alarm, personal attack,
alarm tamper or medical emergency is triggered,
the control unit will activate the alarm
immediately irrespective of what armed mode the
control unit is in.
During an alarm, the control unit will sound the
siren and start to dial the programmed phone
numbers.
If a tamper alarm is activated when the panel is
disarmed the system will not dial out.
Stopping the alarm
1
Key in your PIN code, and then press OK.
The alarm and dialling will stop and the display
will show the device and zone which triggered
the alarm in the Alarm Log.
2
Press any key.
The display will show the telephone call made
if successful.
3
Press any key again to see if the second call
was successful (if programmed).
If nobody has answered the call or only one
recipient has answered the call, the screen will
return to ‘Alarm Off’.
When the log has been displayed the screen
will return to ‘Alarm Off’.
If an alarm is silenced using a remote keypad
or keyfob, the system will only silence the alarm -
not disarm the system. The system can only be
disarmed after an alarm event at the control
panel.
Alarm memory
If an alarm was raised during your absence,
and the alarm sequence has been carried out, the
screen will continue to show ALARM!
When you come back and disarm the system
the siren will sound a 3-second alarm instead of
the normal 2-beep sound.
To clear the display, follow the same steps as
stopping the alarm described above.
Warning
If the siren is activated for 3-seconds
when you disarm your system there could be an
intruder still in your premises.
Using the system
Arm and disarm the system and practice using it. Trigger the alarm by arming the system
and opening protected doors/windows and walking past PIR’s. Now is the time to show
the rest of the family how simple it is to use. The telephone features are yet to be
programmed.
5
Downloaded from www.ukpanels.com