28-13-010_8000316_Rev4
3/14
Place thick Cardboard
Strips either side of
roof trim prior to
cutting to prevent
accidental
scratching
of the roof
body should
the knife slip.
CUT FRONT ROOF TRIM
Place Track on top of roof trim, positioning the end of track on rear trim cut line.
Measure and cut front roof trim 4 mm from front end of Track.
An additional 2 mm either end is required to fit the Track End Caps.
Remove Track from vehicle.
PROTECT ROOF TRIM
Tape thick
cardboard
strips along Track
CUT REAR ROOF TRIM
Using a knife, precisely cut the
width of the rear section of roof
trim as determined from Step 3.
PEEL BACK ROOF TRIM
Using your fingers, carefully
peel back the cut section of
roof trim until the double
sided tape underneath trim
releases.
Continue to peel trim from
roof until trim and double
sided tape is off the vehicle.
It is important that any
double sided tape still on
vehicle is completely cleaned
off before Track fitment.
Without Factory Snorkel
With Factory Snorkel
Work trim backward and forwards to snap
stainless steel section in rubber trim
185 mm
38 mm
4 mm
4
5
6
7
