1033348-/15
Wood floors
• For wood floors or sub-floors under carpet, use supplied
mounting screws and install as with wall plates.
• If feet do not touch the floor, use one or more shims large
enough to cover the bottom of the foot. Do not rotate the
feet more than 1/2 inch.
• Drill 1/8” starter holes through the holes in the feet.
• Insert screws through holes.
• DO NOT OVER TIGHTEN.
INsTAll hOOPs
21
• The holes in the hoops must face the wall.
• Begin at the bottom and install a hoop into
four open couplers.
• Install remaining hoops.
• Center the hoops in the open couplers.
ClOse ANd TIGhTeN COuPleRs
22
• Close the coupler covers.
• Push up the hanging sleeve screws and
hand-tighten the with the included
5/32” hex key.
do not
over-tIgHten
Concrete floors
Do not drill through the feet. The concrete
bit can cause damage to the feet. It may be
necessary to remove the unit to access the
floor and install the anchors in the Anchor Kit
(sold separately).
If mounting to masonry or concrete, you must
use the Anchor Kit (#05111)
23
seCuRe uNIT TO The flOOR If YOu WIll be sTORING heAvY GeAR
24
seCuRe The uNIT TO The WAll
• Drill hole for upper hole of wall plate, if not yet
done.
• Place screws into upper hole of wall plate and
tighten securely.
• Tighten screws in bottom of wall plate or
Universal Mounting Plate (sold separately for
walls with inaccessible studs, part #05103).
read all warnIngs
and weIgHt lImIts
on last Page.
faIlure to read
warnIngs may
cause Injury due to
ImProPer use.
