1033348-14/15
AsseMble CORNeRs ANd hOOPs
• Slide one connector onto each
corner tube.
• Depress the connector peg and slide
all the way into the tube until it clicks
into the corresponding hole.
• Add horizontal tubes to the side tube.
• Connect the half-hoops to the
corners.
33
CONTINue AT sTeP 13 TO ATTACh The uNIT TO The WAll.
Assistance is recommended when installing the corner/hoop assemblies onto the
vertical assemblies.
36
exIsTING INsTAllATIONs ReMOve hOOPs, TheN sIde Tubes —
(NeW INsTAllATIONs beGIN AT sTeP 1)
If you have an installed base unit and you are adding a corner kit
and base unit, you must detach the standing unit from the wall.
34
make sure tHat tHe
Peg Holes face tHe
wall, otHerwIse
tHe couPlers wIll
not close ProPerly.
seT These AsIde
Attach the vertical assemblies to the wall (Step 13).
35
corners AnD
horizonTAl
hoops
Assistance is recommended when installing the
corner/hoop assemblies onto the vertical assemblies.
Corner with entender Kit:
all corner tubes must be
attached directly to vertical
tubes on both sides.
