1033348-11/15
26
25
lOOseN COuPleRs
Use the 5/32” hex wrench
included with the Base Unit to
loosen the coupler screws and
open all couplers.
CleAR The uNIT
Remove gear and accessories
from the installed unit.
sTART heRe TO
exTeNd YOuR
(INsTAlled)
bAse uNIT.
Begin at STEP 1
if this is a new
installation, and
refer to STEP 29.
ReMOve hORIZONTAl hOOPs
• If coupler housings remain attached to hoops,
detach the housings by pulling them from the hoop.
• Leave couplers attached.
• Depress pegs on the
horizontal tubes and pull
side tube away from hoop.
• Leave connectors in the
side tubes.
ReMOve sIde Tubes fROM
The sIde ThAT WIll exTeNd.
AsseMble exTeNded hORIZONTAl hOOPs
• Add horizontal tubes to the connectors attached to the
GroundControl horizontal tubes.
• Depress the connector peg and slide all the way into the tube
until it clicks into the corresponding hole.
• Slide the remaining side tubes onto the connectors.
exTenDeD
horizonTAl
hoops
27
28
29
CONTINue AT sTeP 2
30
• ASSEmBlE vErTICAl POlES
• DrIll, ATTACh unIT wAll
• InSTAll hOOPS
