Yaesu VX-3E, Руководство по эксплуатации

Страница: 83 / 132

VX-3R/E O
PERATING
M
ANUAL
81
CW I
DENTIFIER
S
ETUP
The ARTS™ feature includes a CW identifier, as discussed previously. Every ten minutes
during ARTS™ operation, the radio can be enabled to send “DE (your callsign) K”. The
callsign field may contain up to 16 characters.
Here’s how to program the CW Identifier:
1.
Press and hold in the [
TXPO
] key for one second to enter the Set mode.
2. Rotate the
DIAL
knob to select Set Mode Item 19: CW ID .
Note : Do not forget to pull the
DIAL
knob to rotate the
DIAL
knob.
3. Press the [
TXPO
] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to set this Item to “
ON
” (to enable the CW
ID function).
5. Press the [ V/M
] key momentarily to display any previously-stored
callsign.
6. Press and hold the [ HM/RV
] key for 2 seconds to
clear
any previous callsign.
7. Rotate the DIAL knob to select the first letter/number of your
callsign, then press the [ V/M
] key momentarily to save the first
letter/number and move on to the next character.
8. Repeat the previous step, as many times as necessary, to com-
plete your callsign. Note that the “slant bar” (
–
• •
–
•) is among
the available characters, should you be a “portable” station.
9. If you make a mistake, press the [
BAND
] key to backspace the
cursor, then re-enter the correct letter/number.
10. Press and hold the [
HM/RV
] key for 2 seconds to delete all data after the cursor that
may have been previously stored erroneously.
11. When you have entered your entire callsign, press the [ TXPO
] key momentarily to
confirm the callsign, then press the PTT switch to save the settings and exit to normal
operation.
1) You may check your work by monitoring the entered callsign. To do this,
repeat steps 1- 3 above, then press the [F/W] key.
2) You may adjust the monitoring tone (CW sidetone pitch) via Set Mode Item
21: CW PIT. Available selections are 400 - 1000 Hz (50 Hz/step).
ARTS™
(
A
UTOMATIC
R
ANGE
T
RANSPONDER
S
YSTEM
)