Yaesu VR-160, Руководство по эксплуатации, Страница: 65 / 100

VR-160 O
PERATING
M
ANUAL
63
M
ISCELLANEOUS
S
ETTING
P
ASSWORD
The
VR-160
provides a password feature which can minimize the chance that your trans-
ceiver could be used by an unauthorized party.
When the password feature is activated, the radio will ask for the four digit password to be
entered when the radio is first turned on. You must enter the four digit password using the
DIAL knob and [ V/M
] key (pressing the [
V/M
] key to select the pass-
word digit and rotating the
DIAL
knob to select the password in each
digit). If the wrong password is entered, the microprocessor will shut
down the radio automatically.
To enter the password and activating this feature, use the following procedure:
1.
Press and hold in the [ BANK
] key for one second to enter the Set mode.
2. Rotate the
DIAL
knob to select Set Mode Item 38: PASSWORD .
Note : Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ BANK
] key briefly to enable adjustment of this Set
Mode Item.
4. Press the [ V/M
] key briefly to blink the first digit of the pass-
word.
5. Rotate the DIAL knob to select the first digit of the desired num-
ber/letter (
0
-
9
,
A
,
B
,
C
,
D
,
E
, and
F
).
6. Press the [ V/M
] key to move to the next digit.
7. Repeat steps 5 and 6 to program the remaining numbers/letters
of the desired password.
8. If you make a mistake, press the [
BAND
] key to move back to
the previous digit, then re-select the correct number/letter.
9. When you have finished entering the password, press the [ V/M
]
key and rotate the DIAL knob to select “
ON
” (to activate the
password feature).
10. Press and hold in the [ BANK
] key for one second to save the
new setting and exit to normal operation.
If you wish to disable the Password feature, repeat steps 1 - 3 above, then rotating the
DIAL knob to select “ OFF ”, then press and hold in the [ BANK
] key for one second.
1) We recommend that you to write down the password, and keep it in a safe
place where you can easily find if you forget your password.
2) If you forget your password, you may regain use of the transceiver by
performing the “Microprocessor Resetting” procedure (see page 94). However, the VR-
160 will clear the password, as well as all memories, and will restore all other settings to
factory defaults.