Yaesu FT-991A, Руководство по эксплуатации

Страница: 90 / 158

Page 88 FT- 991 Operating Manual
CW Convenience Features
Checking the CW Memory Contents
1. Be sure that Break-in is still turned “Off” by
[
BK-IN
]
on the LCD.
2. Touch [
MONI
] on the LCD to enable the CW moni-
tor.
3. Touch [
CH1
] - [
CH5
] on the LCD or press the
FH-2
[
1
] - [
5
] key, whichever memory you just recorded
in. You will hear the message played in the sidetone
monitor, but no RF energy will be transmitted.
On-The-Air CW Message Playback
1. Touch [ BK-IN
] on the LCD to enable transmission.
Either Full- or Semi-break-in will be engaged, de-
pending on the setting of Menu item “
056 CW BK-
IN TYPE
”.
2. Touch [ CH1
] - [
CH5
] on the LCD or press the
FH-2
[
1
] - [
5
] key, depending on which CW Memory Reg-
ister message you wish to transmit. The programmed
message will be transmitted on the air.
Note:
If you subsequently decide to use the “Text Memory”
technique for memory storage, please note that a mes-
sage stored using keyer paddle input will not be trans-
ferred over when you select “Text Memory technique”
on a particular memory register (the Menu Mode Setting
is set to “
TEXT
”).
Contest Memory Keyer
Message Memory Programming
(
Using your Paddle
)
1. Set the operating mode to CW.
2. Set [
BK-IN
]
on the LCD to “Off”.
3. Set [ KEYER
] on the LCD to “On”.
4. Touch [
MEM
] on the LCD or press the [
MEM
] key
on the FH-2 . A blinking “ REC ” icon will appear in
the display.
5. Touch [ CH1
] through [
CH5
] on the LCD or press
any of the FH-2 keys numbered [ 1
] through [
5
] to
begin the memory storage process, and the “ REC ”
icon will glow steadily.
6. Send the desired message using your keyer paddle.
Advice:
If you do not start keying within ten seconds, the
memory storage process will be cancelled.
7. Touch [ MEM
] on the LCD or press the [
MEM
] key
on the
FH-2
once more at the end of your message.
Up to 50 characters may be stored in each of the five
memories.
Note:
Care must be exercised when sending to ensure that the
spaces between letters and words are accurately done;
if the timing is off, the spacing may not come out right
in the stored message. For ease in setting up the keyer
memories, we recommend setting Menu item “
012
KEYER TYPE
” to “
ACS
” (Automatic Character Spacing)
while programming the keyer memories.