Getting Started
2.6
Connect the Power Cable
You do not need to set the MAXserver 1600 for 115V or 230V operation. The power supply automatically
adapts to the input voltage.
A grounded AC power outlet should be located within six feet of the back of the MAXserver 1600. You
can use a UL-approved, 3-prong extension cord if necessary, provided it has sufficient current and voltage
capacity. (The cord must have sufficient capacity for the input power, as specified in Appendix A). AC
power must meet the criteria listed in Appendix A.
Complete these steps:
1.
Plug the AC line cord (supplied) into the AC power receptacle on the rear of the MAXserver
1600. (See Figure 2-2 for the location of the power receptacle.)
2.
Plug the other end of the cord into a grounded 3-prong AC power outlet (or a UL-approved
extension cord with sufficient capacity that is plugged into a suitable outlet).
3.
When you apply power, the MAXserver 1600 performs a self test of its circuitry and then proceeds
to load its software. When the unit has finished loading its software, the RUN light flashes slowly
and the LAN light flashes as Ethernet packets are received. (Figure 2-3 shows the locations of
the lights on the front panel.)
If, after several minutes, the front panel lights do not behave as indicated, refer to Chapter 3,
Troubleshooting.
0590
15
