3115T R3 Thin Line Industrial Flat Panel PC Appendix B – Power On Self Test Messages
73
141876(E)
Error Messages
Cause/Solution
SLOT NOT EMPTY
A slot designated as empty by the EISA Configuration Utility actually
contains a board. When this error appears, the system will boot in
ISA mode allowing you to run the EISA Configuration Utility.
SYSTEM HALTED, (CTRL-ALT-DEL) TO
REBOOT ...
The present boot attempt has been aborted and the system must be
rebooted. Press and hold down the CTRL and ALT keys and press
DEL.
WRONG BOARD IN SLOT
PLEASE RUN EISA CONFIGURATION UTILITY
The board ID does not match the ID stored in the EISA non-volatile
memory. When this error appears, the system will boot in ISA
mode, allowing you to run the EISA Configuration Utility.
FLOPPY DISK(S) FAIL (80)
Unable to reset floppy subsystem
FLOPPY DISK(S) FAIL (40)
Floppy type dismatch
HARD DISK(S) FAIL (80)
HDD reset failed
HARD DISK(S) FAIL (40)
HDD controller diagnostics failed
HARD DISK(S) FAIL (20)
HDD initialization error
HARD DISK(S) FAIL (10)
Unable to recalibrate fixed disk
HARD DISK(S) FAIL (08)
Sector Verify failed
MANUFACTURING POST LOOP.
System will repeat POST procedure infinitely while the P15 of
keyboard controller is pulled low. This is also used for M/B burn in
test.
BIOS ROM CHECKSUM ERROR - SYSTEM
HALTED.
The checksum of ROM address F0000H-FFFFFH is bad.
MEMORY TEST FAIL.
BIOS reports the memory test failed if the onboard memory is tested
error.