XVision XSD10Z-2, Руководство пользователя

Страница: 5 / 24

5
4. DIP Switch Setup
PIN 1 2 3 4
FUNCTION PROTOCOL N/P ON
ON
Refer to the Manual
PAL
Reserve
OFF NTSO
Before you install the camera, you should set the DIP switches to configure the camera ID and communication protocol.
COMMUNICATION PROTOCOL CAMERA ID
4.1 COMMUNICATION PROTOCOL SETUP
z
Select the appropriate Protocol with DIP switch combination
SWITCH STATE 3
P0 (PIN 1) P1 (PIN 2)
OFF OFF PELCO_D, 2400 bps
ON OFF PELCO_D, 9600 bps
OFF ON PELCO_P, 4800 bps
ON ON PELCO_P, 9600 bps
z If you want to control using DVR or P/T controller, their protocol must be identical to camera. Otherwise, you can not control
the camera.
z If you changed camera protocol by changing DIP switch, the change will be effective after you reboot the camera.
z The factory default of protocol is Pelco-D, 2400 bps
4.2 CAMERA ID SETUP
z ID number of camera is set using binary number. The example is shown bellow.
z
The range of ID is 1~255. Do not use 0 as camera ID. Factory default of Camera ID is 1.
z
If you want to control a certain camera, you must match the camera ID with Cam ID setting of DVR or Controller.
4.3 RESERVED FOR SUPPLIER
z Since Pin 3 and Pin 4 are only for the supplier. Do not change their original state. If you change one of these, full operation
cannot be achieved
z
Pin 3
- PAL / NTSC system selection of Camera. Do not change this pin.
z
Pin 4 - Factory default is ON state. This pin is used for system firmware upgrade. Do not change this pin .
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4
OPTIONS ADDRESS (ID)
PIN 1 2 3 4 5 6 7 8
FUNCTION A0 A1 A2 A3 A4 A5 A6 A7
ON 1 2 4 8 16 32 64 128
OFF 0 0 0 0 0 0 0 0