Xvent XHOUSE-300, Инструкция по установке и эксплуатации

Страница: 41 / 47

41
Version 1 – GBR (25/10/2022) D-502-0287
- For cleaning the unit from coarse dirt or dust, use a vacuum cleaner or damp cloth with a common
cleaning agent (e.g. soapy water).
7.1. Inspection - cleaning the exterior of the unit
- Externally inspect the unit over the entire surface of the unit casing with the plastic cover removed.
- To remove the plastic design cover, loosen the M6x20 plastic screws on the bottom of the unit. Slide the
cover upwards and store it securely.
- Replace the cover using the reverse procedure. Tighten the screws by hand
7.1.1. Visual Inspection of the Unit Casing
- The unit can be cleaned on its entire surface.
- Visually inspect the outer casing of the unit for excessive soiling, damage:
o
If the smooth surfaces of the casing are dirty, wipe them with a damp cloth with a common
cleaning agent (e.g.: soapy water),
7.1.2. Visual Inspection of the Supply Cable
- Visually check that the supply cable is not damaged, loosen, or torn from the connecting peripherals.
- In case of damage, consult with the person competent for this activity with the valid authorisation and
knowledge of the relevant standards and directives.
7.2. Inspection - Cleaning of the unit interior
- Pay particular attention to the disassembly of the internal components of the unit. Improper
disassembly may cause the unit to malfunction or limit its functions.
- Remove the front plastic design cover - see chapter 7.1.
- Unscrew the 5x M6x25 screw securing the unit cover
- Unscrew the Ø 3.5x20 self-tapping screw securing the control cover plate
- Remove the filter caps using the fabric straps
- Remove the filters - see chapter 6.1.
- Remove the plastic cover using the holes of the filters
- Pull out the unit cover (position 5)
1) UNSCREW THE BOLTS
2) REMOVE FILTER CAPS AND FILTERS
1) LOOSEN THE
HAND SCREWS
2) REMOVE THE
FRONT PLASTIC
COVER
Fig. 51
Fig. 53
Fig. 52