Xtreme Power Conversion Corporation
Web/SNMP Cards
Page 21
UPS Management
Current Status
Remote Control
This page is to provide remote UPS test functions. Choose the test item, then click on ‘Apply’ to execute it.
(Please refer to the UPS manual for individual UPS Test functions).
If you are using a Contact Closure UPS, you will only be able to use the function ‘ Turn off UPS when AC Failed’.
10 Second Test
This to perform 10 seconds UPS self test.
Deep Battery Test
This function is to initiate XX minute deep battery test.
Test Until Battery Low
When initiated, UPS will test Battery until battery low.
Cancel Test
This function is to abort a test when it is in progress.
Turn off UPS when AC failed / Reboot UPS
Selecting ‘ Turn off UPS when AC failed’ will turn off the UPS. You can reboot the UPS by selecting ‘ Re-
boot UPS.
Put UPS in Sleep mode for XX minutes / Wake up UPS
When the UPS is put into Sleep mode, it will not provide output power. The UPS will provide power again
after Sleep mode time is complete.
Wake up UPS
When initiated, UPS will be awakened from sleep.
