xtra XR10, Оригинальное сервисное руководство

Страница: 4 / 20

3 |
P a g e
GB
Initial Set Up
After unpacking, clean and allow the cabinet to stand for 2 hours before turning on
(cleaning directions supplied within this manual).
Ensure the cabinet is situated away from
both hot and cold air sources, as this will affect its performance. Make sure that a minimum
clearance of 10cm around the cabinet is available for ventilation and effective operation.
Install the drip tray underneath the cabinet after placing the unit in position.
Connect the unit to a suitable mains power outlet and turn the supply on. Do not plug or unplug the
unit with wet hands.
Standby
When left for several minutes the cabinet will automatically switch to standby, this helps reduce
energy consumption.
When in standby mode the cabinet will show the middle LED on the main display flashing green
slowly.
During this time the controller is still connected to the mains and standby does not cut off the main
power supply. As a consequence only the compressor and condenser are switched off during this
time.
If the cabinet is going to be unused for a prolonged amount of time than the units power supply
should be switched off and or disconnected from the mains supply.
To exit standby press any button on the keypad and the controller will revert to displaying the
current temperature.
Button 1 Button 2 Button 3 Display 1 LED 4 LED 5
LED 1 LED 2 LED 3 Display 2 LED 7 LED 6
Buttons & Icons
Button 1 Decrease Value/ Information LED 1 Cycle Indicator ‘ Soft Chill’
Button 2 Select Cycle and Increase Value LED 2 Cycle Indicator ‘Defrost’
Button 3 Start/Launch Cycle LED 3 Cycle in Progress
Display 1 Main Temperature
Display 2 Cycle Status Display
Other Visible Indicators:
LED 4 Temperature shown in °C LED 6 Probe Cycle Mode Active
LED 5 Temperature shown in °F LED 7 Timer Cycle Mode Active