xtra XR10, Оригинальное сервисное руководство

Страница: 14 / 20

13 |
P a g e
GB
Cleaning the Condenser
XR10 & XR20 models will clearly see the condenser after removal of the unitcover.
XR35 model will have to also remove the Condenser Fan Plate and motor.
To do this unscrew the two fixing screws positioned on
The top of the condenser fan plate.
Tilt the plate forward on the rubber pivots and
then remove from the unit. You will now be
able to access the condenser for cleaning.
Once the unitcover is removed please do not leave the unit unattended.
Cleaning the condenser should be scheduled every 3 to 6 months and carried out by a service
engineer. Use a soft brush or vacuum cleaner to remove dirt/dust.
If there are any stubborn grease deposits left on or through the condenser call your supplier to carry
out a full service (this is normally chargeable). Failure to maintain the condenser may invalidate the
warranty of the condensing unit and cause premature failure of the motor/compressor. DO NOT
use
a wire brush to clean the condenser. Re-fit any panels removed after cleaning.
Access to the Evaporator
After opening the door you will be able to see the evaporator assembly situated at the rear of the
cabinet.
> Firstly, remove all shelves or pans and ladderacking before trying to proceed with the
following instructions.
> To remove the fan and or guard unscrew the guard fixings and pull it towards you.
> To access the reducer valve, evaporator coil and air probe, remove one or more of the
locking screws and then pivot the fan motor baffle on its rubber mounts. This baffle can be
totally removed if required.
Rear of Cabinet/ Birds Eye
View
Evaporator
Coil
Expansion
Valve
Locking
Screw
Racking
Evaporator
Fan
Rubber
Pivot
Air
Probe
Fixing Screws