65
Digital I/O programming
The following is an Assembly program, which demonstrates how to read and write
the data of GPIO
.
;------------------------------------------------------------------------------------------------------
; Configuration the Digital IO port is 50Ch, and Bit2, Bit3, Bit4, Bit5
; Bit3/Bit2 (GPO-0 ~ GPO-1 Write data port)
;
When set to a “1”, respective GPO port is programmed as ‘High’.
;
When set to a “0”, respective GPO port is programmed as ‘Low’.
; Bit5/Bit4 (GPI-0 ~ GPI-1 Read data port.)
;
Its respective bit only read.
;------------------------------------------------------------------------------------------------------
Mov
Mov
dx,50ch
al,0ch
; Digital I/O port 50Ch
; set GPO-0(Bit3) ~ GPO-1(Bit2) value is “xxxx11xxb”
Out
dx,al
; Set GPO-0 ~ GPO-1 value
Mov
In
dx,50ch
al,dx
; read GPI-0 (Bit5) ~ GPI-1 (Bit4) value “xx11xxxxb”
Содержание TCD-N2600-C2G2-2
