By default, the entire screen is set as motion detection area where is
indicated with green border around the image. To mask a specific area, you
can click
button to cancel the full screen detection border; then
Left-Single-Click and drag a rectangle. A green rectangle will mark the area of
it. Also, you can set any other areas. Any activities in the motion detection
areas will trigger recording, depending on the reaction mode; and alarms may
be generated along with electronic map icons flashing in alert mode. Click
button to test the sensitivity of motion detection. The sensitivity can
be adjusted by dragging the slider bars below the motion detection window,
The Sensitivity value bar is used to adjust the sensitivity of the area you
selected. The sensitivity value is smaller the motion detection is more
sensitive.
The motion value bar is used to set the minimum acreage of full screen to
trigger alarm. Its unit is percent, if the acreage of motion area exceeds the
setting value of the areas you selected, system will trigger alarm. The default
value of Sensitivity and Motion is 2 and 5%.
Note:
Содержание Hybrid NDVR system
Страница 1: ...Hybrid NDVR system USER S GUIDE...