XSPC RayStorm V3 Kit, Руководство пользователя

Страница: 6 / 20

Preparing the WaterBlock
2. Push the 5mm LED into the LED holder. You might
prefer to do this after installing the kit.
2. Push the two 3mm LEDs into the LED holders. You
might prefer to do this after installing the kit.
1. Attach the fittings to the inlet and outlet of the pump.
Do not apply too much pressure as this can strip the
threads.
Preparing the Photon Pump/Reservoir
1. Attach the fittings to the inlet and outlet of the pump.
Use the G1/4” blanking plug to block any unused
outlet (see page 7). Do not apply too much pressure
as this can strip the threads.
2. Slightly kink the LED wire and push the LED into the
hole on the base of the reservoir. You might need to
twist the LED slightly until it slots into place.
2. Push the 5mm LED into the LED holder. You might
prefer to do this after installing the kit.
1. Attach the fittings to the inlet and outlet of the pump.
Use the G1/4” blanking plug to block any unused
outlet (see page 7). Do not apply too much pressure
as this can strip the threads.
1. Attach the fittings to the inlet and outlet of the pump.
Use the G1/4” blanking plug to block any unused
outlet (see page 7).
Page 5/18
Preparing the Bay Pump/Reservoir
Preparing the Ion Pump/Reservoir