XSPC RayStorm V3 Kit, Руководство пользователя

Страница: 14 / 20

Filling the System (Ion/Photon Pump/Reservoir)
1. Move the pump so you can easily access the fill
cap.
2. Use a small coin to undo the pumps fill cap.
3. Use a small funnel to avoid spilling the coolant.
5. Top up the coolant to the top of the viewing window on the front of the pump/reservoir.
6. Place your PSU outside of the case and attach it to
the pumps 4pin connector.
7. Attach the PSU starter block to the 24pin connector.
This will allow the PSU to start without the
motherboard.
8. When the pump starts the coolant level in the
reservoir will drop. You should keep topping up the
coolant level while the rest of the system fills up.
9. When the coolant level is stable you should leave
the pump running for 24 hours to check for leaks. This
will also allow any remaining air to bleed from the loop.
After the leak test you can re-install the motherboard
and other PC components into the case.
4. We recommend using a premixed coolant like XSPC
EC6, or concentrate coolant like ECX. This will protect
the components and stop biological growth in the loop.
Page 13/18