XS Scuba Inspire Regulator, Руководство по обслуживанию

Страница: 14 / 38

14
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
Disassembly Procedure
Inspire 2nd Stage
1. Remove MP Hose (28)
A. Using an 11/16” wrench, hold lock nut (8)
stationary while removing the hose swivel nut
with a 17mm wrench.
B. Remove the o-ring (14) from inside the hose
swivel. Exercise caution not to scratch the
o-ring groove.
2. Remove front cover assembly.
A. Unscrew front cover retainer ring (12) CCW.
If it is too difficult to remove by hand, use the
regulator cover removal tool TL117.
B. Remove the front cover (12,11), the diaphragm
washer (10) and the inhalation diaphragm (9).
Carefully inspect the diaphragm for small tears
or holes. If found in good condition, it may be
reused.
3. Remove the Mouthpiece (3)
A. With a pair of side cutters, carefully cut the tie
wrap (2) and discard. Be careful not to let side cut-
ters nick the mouthpiece (3).
B. Remove the mouthpiece (3). Inspect the mouth-
piece for holes or tears, especially around the seal-
ing area. Replace as needed.
4. Remove the exhaust cover (5) and inspect the
exhaust valve (4)
A. Using the backside of the TL136 Multi-Purpose
Tool, enter the right exhaust port and push on the
retaining clip until the right side of the exhaust cover
(5) disengages. Lift the exhaust cover (5) off of the
main housing (1).
1A
1B
2A
2B
3A