XS Scuba Inspire Regulator, Руководство по обслуживанию

Страница: 10 / 38

10
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
Disassembly Procedure – Inspire
1st Stage
CAUTION: Use only a plastic or brass o-ring
removal tool when removing o-rings to prevent
damage to the sealing surface. Do not use a steel
dental pick or any other steel instrument.
1. Remove all hoses and port plugs (30,32)
from the first stage.
A. MP hoses typically require a 9/16” wrench while
HP hoses typically require a 5/8” wrench.
B. MP plugs (32) typically use a 5/32 hex key while
HP plugs (30) typically use a 3/16 hex key.
2. Using a brass or plastic o-ring removal tool,
remove the hose o-ring from the threaded
male end of each hose. Pull back the hose
protectors and inspect each crimped ferrule.
The hose should not be pulling out of the
ferrule or be swollen or bulbous in any way.
If it is, it must get replaced.
3. Remove the o-rings (29,31) from each port plug
(30,32).
4. Thread the HP (7/16”-20 UNF) end of the TL122
Regulator Support Handle / Vise-Mounting Tool
into the HP port. Be sure to fully engage the
threads.
NOTE: It will be necessary to use a bench
mounted vise to hold the first stage securely
throughout the next procedures. The first stage
must be mounted outside of the vise by use of
the TL122 Support Handle / Vise-Mounting Tool
installed into the HP port.
5. Securely mount the tool in a vise.
6. Remove connector assembly
A. Inspire with yoke connector
i. Remove the yoke screw (2).
ii. Using the ¾” socket from the TL123 Yoke
Retainer Socket Set, loosen the yoke retainer (7)
until it can be removed by hand.
CAUTION: Due to the necessary reduction
in wall thickness of the TL123 ¾” socket, exceed-
ing 50 pounds of torque will result in cracking of
the socket.
If the yoke retainer (7) is unusually tight, don’t risk
breaking the socket. Rather, use a large 12” or 15”
crescent wrench. Place the jaws of the wrench
around the yoke (3) and clamp on to the large, hex
yoke retainer (7). Carefully loosen it until it can be
removed by hand. Remove the yoke retainer (7),
the yoke (3), dust cap (9) and saddle (10).