XS Scuba Inspire Regulator, Руководство по обслуживанию

Страница: 24 / 38

24
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
v. While continuing to hold the yoke retainer (7)
assembly upside down, pass it through an upside
down yoke (3). Add the upside down dustcap (9)
and upside down saddle (10).
NOTE: Keeping the assembly upside down
prevents the bottom o-ring (8) from falling out of its
recess.
vi. While holding the connector assembly and
the body upside down, install the entire yoke
connection assembly into the main body. Turn it
by hand as far as it will go.
vii. Mount the body back into the vise.
viii. Using the ¾” (19 mm) socket (TL123), with an
extension attached to a ft/lb torque wrench, apply
a torque to the retainer of 24 ft/lbs (1 Nm).
ix. Install the yoke knob.
B. Inspire with DIN connection (Refer to the DIN
version exploded parts diagram):
i. Add the replacement o-ring (8) to the bottom of
the DIN housing(7).
ii. While holding the DIN housing (7) upside
down, place the upside down saddle (10) over it.
NOTE: Keeping the assembly upside down
prevents the bottom o-ring (8) from falling out of its
recess.
iii. Thread the DIN housing (7) up into the main
body of the regulator. Make certain that
the o-ring (8) remains seated.
13A
13A
13A
13A
13B
13B