1.
Turn on main power switch with bottles in place
(Green switch located right side).
2.
Make sure the Pressure Release Switch is in the off
position (down).
3. Place bottles under spouts.
4. With gas line inserted, turn on spout switch and
allow gas to flow through the filling system.
5.
Turn spout switch to middle position, and then back
up to full on position. Repeat this several times to
fully allow the purge path to ventilate.
6.
Turn the release pressure knob at top of machine
clockwise to close valve about half way,
approximately ten turns.
7. Turn on the Pressure Release Switch for maximum
ventilation through the flow path.
8.
When you are satisfied with the results, turn off
both the Fill Switches and Pressure Release
Switches (down) and then you can remove the
bottles.
9. Turn off the air/gas supply and remove all the hoses
10. Turn off the filler.
Note:
Instead of using CO2, you can use an oil free air
compressor as well.
265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | [email protected]
15
| XpressFill Systems LLC
Part Two
Attach cleaning hoses as pictured below. Hosing and connectors are supplied in the accessory packet.
