XPower Easy Max, Инструкция по эксплуатации

Страница: 34 / 52

- 34 -
4. Instructions for installation and use
Wiring diagram
Wiring diagram
To the
sensor
To the
sensor
4.2 wiring
4.2.1 wiring diagram and relative instructions
Single-phase input and single-phase output Single-phase input and three-phase output
Three-phase input and three-phase output Notes on wiring
to the pump
to the pump
to the power
supply
1~230V AC
50/60Hz
to the power supply
Wiring diagram
To the
sensor
to the pump
to the power
supply
1) Do not connect the main power supply circuit to the output terminals U, V and W
2) Perform wiring only after disconnecting the current
3) Check that the rated voltage of the inverter and the input voltage are coherent
4) The inverter cannot be subject to the dielectric withstand test
5) The screws tightening torque is 1.7 N.m
6) Make sure to perform earthing before wiring the terminals of the main circuit
7) Connect the input current after installing the panel.
When the current is active, do not remove the panel
1~230V AC
50/60Hz
1~230V AC
50/60Hz
3~230V AC
50/60Hz
3~400V AC
50/60Hz
3~400V AC
50/60Hz
GB