XM-014232-PC
65
APPENDIX A: PARAMETER SUMMARY
The following section summarises the XVF3510 parameters which are programmable via the control
interfaces or flash data partition. These parameters allow the setup of the XVF3510 processor’s
interfaces and tuning of the internal signal processing.
To aid quick reference of the key parameters the summary is split into two sections. The first details
the most frequently used parameters which are required for interface configuration and basic control,
and the second detail advanced parameters which will not generally need to be modified. Further
details on the specific usage of parameters are discussed in the previous sections of the document
and referenced below for convenience.
NOTE: The parameters shown below can be formatted into Read and Write commands, where
appropriate by adding the prefix ‘GET_’ and ‘SET_’ for Read and Write respectively.
BASIC PARAMETERS
The following table lists the parameters which allow configuration and control of the device in most
applications.
Table A-1 Basic parameter summary ('-' used to indicate not applicable)
PARAMETER
READ /
WRITE
DESCRIPTION
3510-UA
DEFAULT
3510-INT
DEFAULT
VERSION
R
Firmware version
v4.0.0
v4.0.0
DELAY_SAMPLES
R/W
Configurable delay in samples
0
0
STATUS
R
Status
0
0
DEVICE_TO_USB_BIT_R
ES
R/W
Device to USB bit resolution
16
-
DEVICE_TO_USB_RATE
R/W
Device to USB rate
48000
-
GPI_INT_CONFIG
W
Sets the interrupt config for a specific pin
-
-
GPI_INT_PENDING_PIN
R
Read whether interrupt was triggered for
selected pin
-
-
GPI_INT_PENDING_POR
T
R
Read whether interrupt was triggered for
all pins on selected port
-
-
GPI_PIN
R
Read current state of the selected GPIO
pin
-
-
GPI_PIN_ACTIVE_LEVEL
W
Set the active level for a specific GPI pin.
0: active low 1: active high
0
0
GPI_PORT
R
Read current state of the selected GPIO
port
-
-
GPI_READ_HEADER
R/W
Sets the selected port and pin for the next
GPIO read
0 0
0 0
Содержание VocalFusion XVF3510
Страница 1: ...VocalFusion XVF3510 USER GUIDE V4 0...