The
PAD
sets the sensitivity of the transient detection. When moving the dot you hear what the transient
follower detects, helping you finding the right position. More detection occurs when the dot goes to the top
and detection can occur more often when it goes to the right.
LVL OUT
sets the level of this control signal.
12.5.2
Envelope follower
The envelope follower provides an envelope-like control signal: The
ATTACK
and
RELEASE
knobs set the
time this control takes to raise the input signal level, then to return to zero after the input signal has
ceased.
LVL OUT
sets the level of this control signal.
12.5.3
Pitch Tracker
This module extracts the pitch of the input signal. The resulting pitch signal can then be applied to the
oscillators, but it can also be used to modulate any other modules, via the connection matrix.
QUALITY:
This knob sets the smoothing of the pitch tracking. Turned to the left, the smoothing is minimal and
the modulation is almost unpredictable, whereas when turned to the right, the smoothing is maximal, and the
modulation is very slow. When applied to oscillators, it creates a glide effect.
SNAP
: This switch activates the tune option of the pitch tracker: the pitch will be tuned to scale notes.
ZERO:
This double-knob
shifts the pitch. It allows you to change the pitch of all the modules that use the pitch
tracker signal. The inner ring of the knob adjusts the shift in semi-tones, while the external ring adjusts it in
octaves.
LOW FREQ:
This
knob sets the lowest frequency of the pitch tracker. It sets the lowest note that the pitch
tracker can handle.
HIGH FREQ:
This knob sets the highest frequency of the pitch tracker. It sets the highest note that the pitch
tracker can handle.
