In the Trig tab, you can easily setup a connection
between a trig source and a trig destination.
The trig destinations are obviously the envelopes
but also the LFO reset (and Delay), as well as the
sequencer Start, Stop and Reset.
A trig delay has also been integrated: this function
allows delaying the keyboard trig information. This
delay is set by the
DELAY
knob in either
milliseconds, or a multiple of the DAW tempo when
the
SYNC
switch is engaged.
Note
: Only the trig information is delayed. Velocity
and keyboard follow are not taken into account.
As you can see, the keyboard is sending a note ON
trig and a Note GATE information. This is used to
control the envelope for sustain and looping (see the
envelope chapter)
Finally, in this keyboard panel you will fine the
GLOBAL LEVEL
, which is applied after all the internal
treatment. The
GLOBAL
TUNE
, which sets the overall tuning of the synthesizer, is also found here.
Please note this parameter is a global parameter, and is not saved within a preset.
The
ANALOG
knob increases or decreases the internal instability of the modules emulating the random
variance of vintage equipment.
The
GLIDE TIME
sets the rate at which the keyboard will alter its pitch control information.
12.5 Input modules
When using the
XILS 4
as an effect processor, the input travels through the Input modules, before being
sent to the Main matrix.
These input modules can also be used as new modulation sources.
12.5.1
Transient follower
The transient follower provides a trig information (to be used in the keyboard trig matrix) as well as an
envelope-like control signal: The
RELEASE
knob sets the time this control takes to return to zero, after a
transient has been detected.
