Xerox Versant 80 Press, Руководство системного администратора

Страница: 103 / 230

2. Open the cover of the Automatic Document Feeder (ADF). Notice that the Control
Panel now displays the Auto Alignment Adjustment screen. The instructions on this
screen will assist you in performing the next several steps. Notice that the bottom
right of the screen displays: Scan Page(s): 0.
The next series of steps will be performed 4 times; twice for each side of the Alignment
Adjustment Calibration Chart that you printed.
3. To position the Calibration Chart and the Background Plate onto the glass, perform
the following:
a) Place the Background Plate on the document glass and align it to the rear left
corner, as shown on the UI.
The all-black side of the document should be placed face down on the document
glass. The side of the document with the instructional icons should face up. Note
that these icons are identical to those displayed on the UI.
b) Select one of the five Calibration Charts that you printed.
c) Inspect the Calibration Chart to find the side of the document that contains a
single black square printed in the left-hand margin.
d) Orient the document so that this single black square is in the lower left-hand
quadrant of the page as you hold the document.
e) Slide the chart under the Background Plate that you previously placed on the
document glass.
Tip
It is important to preserve a black margin around the Alignment Adjustment
Calibration Chart.
f) Align the chart laterally (left to right) so that it is at least 20 mm to the right of
the left-hand edge of the glass, and not skewed more than 15 degrees.
5-5 Xerox ® Versant ® 80 Press
System Administration Guide
Simple Image Quality Adjustment (SIQA)