Xerox PrimeLink B9100, Руководство пользователя

Страница: 273 / 484

N E W Z E A L A N D
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, it does not provide any sort of warranty, and it does not imply that any Telepermitted
product is compatible with all Telecom network services. Above all, it provides no assurance that any item will
work correctly in all respects with another item of Telepermitted equipment of a different make or model.
The equipment may not be capable of correct operation at the higher data speeds designated. 33.6 kbps and
56 kbps connections are likely to be restricted to lower bit rates when connected to some PSTN
implementations. Telecom will accept no responsibility for difficulties that arise in such circumstances.
2. Immediately disconnect this equipment should it become physically damaged, then arrange for its disposal or
repair.
3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom customers.
4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is no
guarantee that Telecom lines will always continue to support pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to
'bell tinkle' or noise and cause a false answer condition. If you encounter such problems, do not contact the
Telecom Faults Service.
6. DTMF tones dialing is the preferred method because it is faster than pulse (decadic) dialing and is readily
available on almost all New Zealand telephone exchanges.
W Waarrnniinngg::
No '111' or other calls can be made from this device during a mains power failure.
7. This equipment may not provide for the effective hand-over of a call to another device connected to the same
line.
8. Some parameters required for compliance with Telecom Telepermit requirements are dependent on the
equipment (computer) associated with this device. The associated equipment shall be set to operate within the
following limits for compliance with Telecom Specifications:
For repeat calls to the same number:
• There shall be no more than 10 call attempts to the same number within any 30 minute period for any
single manual call initiation, and
• The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt
and the beginning of the next attempt.
For automatic calls to different numbers:
The equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is no
less than five seconds between the end of one call attempt and the beginning of another.
9. For correct operation, total of the RNs of all devices connected to a single line at any time should not exceed
five.
S O U T H A F R I C A
This modem must be used in conjunction with an approved surge protection device.
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide
273
Regulatory Information