Xerox Phaser 8510, Руководство пользователя

Страница: 32 / 281

Configuring the Network Address
Phaser® 8560MFP/8860MFP Multifunction Printer
2-6
Dynamic Methods of Setting the Printer’s IP Address
Set the product’s IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
■ DHCP
■
CentreWare IS
■ AutoIP
Enabling DHCP on the Printer
Verify that the product DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
Note: To determine the product’s IP address, select
Product Identification
. On the control
panel, press the System button, select Information , press the OK button, select Product
Identification
, and then press the OK button to view the product’s IP address.
See also:
Control Panel Features on page 1-10
Information Required for Manual IP Addressing
Information Comments
Internet Protocol (IP) address of the product Format is xxx.xxx.xxx.xxx , where xxx represents
a decimal number from 0–255.
Network Mask If you are unsure, leave this blank; the product
chooses an appropriate mask.
Default Router/Gateway address Router address is required to communicate with
the host device from anywhere other than the
local network segment.