![background image](http://html1.mh-extra.com/html/xerox/phaser-790dp/phaser-790dp_getting-started-manual_3912476059.webp)
Adding memory to the Printer
1. Setting up the Phaser 790
Xerox Phaser 790 Getting Started
1-49
Adding memory to the Printer
You will need a phillips head screwdriver to perform this procedure.
CAUTION
•
Protect the memory card from static electricity by keeping it in the anti-
static bag until you are ready to install it.
•
Handle the card by the top or side edges only. Do not touch the card
components or the brass connector edge.
•
Avoid placing the card near magnetic devices, such as a pc monitor.
•
Avoid exposing the card to direct sunlight, high temperatures, or
humidity.
1.
Switch OFF the power to the Printer.
0 301073A-WOL
2.
Disconnect the power cord from the rear of the Printer.
3.
Remove the three screws
from the upper right-hand side panel of the
Printer.
301083
Содержание Phaser 790DP
