Safety Notes
15
A ground fault interrupter is embedded in
this product. If current leakage occurs, the
ground fault interrupter automatically cuts
off power circuit to prevent electric shock
and a fire accident. The ground fault
interrupter is normally in the Reset position
(where the <RESET> button is in a
pressed-in state). Check once a month if
the ground fault interrupter works properly
in accordance with the following
procedures:
1.
Switch off the product.
2.
Press the <TEST> button located on
the rear left side of the product, with a
thin stick or similar object.
3.
Make sure that the <RESET> button
is popped up.
4.
After the confirmation, press the
<RESET> button to exit the test
mode.
If the circuit does not work properly, contact
your local Fuji Xerox representative.
Do not attempt to remove a paper jammed
deeply inside the product, particularly a
paper wrapped around a fuser or a heat
roller. Otherwise, it may cause injuries or
burns. Switch off the product promptly and
contact your local Fuji Xerox
representative.
To move this product to another location,
contact your local Fuji Xerox
representative.
Ventilate well during extended operation or
mass copying. It may affect the office air
environment due to odor such as ozone in
a poorly ventilated room. Provide proper
ventilation to ensure the comfortable and
safe environment.
Consumable
Store all consumables in accordance with
the instructions given on its package or
container.
Use a broom or a wet cloth to wipe off
spilled toner. Never use a vacuum cleaner
for the spills. It may catch fire by electric
sparks inside the vacuum cleaner and
cause explosion. If you spill a large volume
of toner, contact your local Fuji Xerox
representative.
Never throw a toner cartridge into an open
flame. Remaining toner in the cartridge
may catch fire and cause burn injuries or
explosion.
If you have a used toner cartridge no longer
needed, contact your local Fuji Xerox
representative for its disposal.
Keep drum cartridges (or drum if not a
cartridge type) and toner cartridges out of
the reach of children. If a child accidentally
swallows toner, spit it out, rinse mouth with
water, drink water and consult a physician
immediately.
When replacing drum cartridges (or drum if
not a cartridge type) and toner cartridges,
be careful not to spill the toner. In case of
any toner spills, avoid contact with clothes,
skin, eyes and mouth as well as inhalation.
If toner spills onto your skin or clothing,
wash it off with soap and water.
If you get toner particles in your eyes, wash
it out with plenty of water for at least 15
minutes until irritation is gone. Consult a
physician if necessary.
If you inhale toner particles, move to a fresh
air location and rinse your mouth with
water.
If you swallow toner, spit it out, rinse your
mouth with water, drink plenty of water and
consult a physician immediately.
Fuser Safety
When removing the fuser unit, always
switch off first and wait for 30 minutes until
it cools off.
<RESET> button
<TEST>
button
