Xerox DocuPrint 240A, Руководство пользователя, Страница: 80 / 165

80
4 Settings on the Control Panel
„
PJL
*2 (refer to P. 94)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
USB
Select this to use USB ports.
„
Port Status
Specifies whether to enable or disable the USB port when the printer turns on. The default
is [Enable], which means the USB port is available.
Important
• If the memory is running out, you need to disable the port(s) you are not using or change the memory
allocation from [Allocate Memory].
„
Print Mode
*1 (refer to P. 94)
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type.
Note
• [PS] is displayed only when the PostScript software kit (optional) is installed.
„
PJL
*2 (refer to P. 94)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, it
should be set to [Enable]. The default is [Enable].
„
Auto Eject Time
*3 (refer to P. 94)
Sets the time interval for the printer to automatically print the remaining data when no further
data is received for a continuous period.
The time can be set between 5 to 1275 seconds in increments of 5 seconds. The default is
[30 Secs]. When no data is received for the period specified here after the last data was
received, the printer determines it as job end.