Xerox 460, Справочное руководство

Страница: 326 / 352

Page 15 - 8 Xerox Document Centre Reference Guide
Paper
Handling
(cont’d)
Repeated Check Tray
Messages on the User
Interface and the paper is
loaded in the tray
l
Adjust the edge guides against the stack of
paper in the tray.
l
If the edge guides were not set against the
paper stock in the tray when Start was
selected, delete the job in the job queue and
begin again.
Paper Curls
l
Load the paper in the paper trays seam side
of the paper up. Load the paper in the High
Capacity Feeder and Bypass Tray with the
seam side down.
l
Load non-standard media in the Bypass
Tray.
l
If the paper curls excessively, flip the paper
over in the applicable paper tray.
The Finisher does not stack
the output correctly
l
Unload the finisher tray frequently.
Depending on your machine configuration
there may be a pause button on the side of
the finisher.
l
Do not remove stapled sets while the
finisher is compiling.
The Finisher does not
staple or staple well
l
The finisher does not staple stacks of more
than 50 sheets of 20 lb. paper.
l
Use less than 50 sheets of paper if they are
heavier than 20 lb.
l
Check the User Interface for a fault
message indicating no staples. Replace the
staple cartridge.
Problem Symptom Recommendation
The seam refers to the side of a
ream of paper with a split in the
wrapping. It may also be
referred to as arrow side first.