XS26GS Managed Optical Ethernet Switch User Manual
34
32768 seconds. The default value is 30 seconds.
Tx Hold:
TTL multiplier. TTL of TLV carried in LLDPDU is used to set the aging time on the
neighbor device. Since TTL of TLV = TTL multiplier ×
Tx Interval
, the aging time on the
neighbor device can be adjusted by the TTL multiplier. The range of this value is from 2
to 10, and the default value is 4.
Tx Delay:
the delay between successive LLDP packets which are initiated by port
parameter changes. The range is from 1 to 8192, and the default value is 2.
Reinit Delay:
in the case of
LLDP Status
mode change, the port will initialize the
protocol state machine, and the switch will need to wait for
Reinit Delay
to be able to
start the next initialization. The range of this value is from 1 to 10 seconds, and the
default value is 2.
Fast Count:
number of fast sending packets. It is in the range of 1 to 10, and the default
value is 3.
2.10.2
Neighbor Information
This page shows the
Local Port, Chassis Id
of a local device
,
and the
Remote Port ID,
System name, Port description, System Capabilities
, and
Management Address
of a neighbor device.
2.10.3
LLDP Statistics
This page shows the statistics
Tx Frames, Rx Frames, Rx Error Frames, Discarded
Frames, TLVs discarded, TLVs unrecongnized
,
Org.TLVs discarded,
and
Age out
packet counts
of LLDP packets on each Ethernet port.