XCPC-9100 Xembedded,
Inc.
k. Selecting menu item ‘w’ permanently writes the configuration to flash. When selected, it will
give a response confirming configuration was saved.
l. Selecting menu item ‘d’ will display the current VLAN configuration. (Note in Minicom, use
SHIFT+Page Up to scroll up the screen) Default configuration is ports 0 thru 7 part of VLAN
0 and all other VLANs empty. Verification should be done to assure module is setup
correctly.
m. Selecting menu item ‘x’ will take you to the top Xembedded menu.
n. When done power off the chassis.
o. Remove the XCPC-9100, setup is complete.
24
Содержание XPMC-9100
