Xembedded XPMC-9100, Руководство пользователя

Страница: 29 / 32

XCPC-9100 Xembedded, Inc.
•
Two XPMC-6710s with both Ethernet ports configured to the back P4 connector.
This is configured via the SW3, position 1 and 4 ON and all others OFF.
•
PC work Station capable of running a terminal program with Communication port set to
115.2K baud rate.
•
CompactPCI, PICMG 2.16 Chassis with a Switch Fabric board to monitor the PICMG
2.16 channels from the XCPC-9100.
VLAN CONFIGURATION
o
Make sure SW9 on the XCPC-9100, position 3 is off.
o
Plug the 3pin to DB-9 serial cable from the PC work station to P3 on the XCPC-9100.
P3 is keyed but be sure to observe pin1 for this connection.
o
Insert XCPC-9100 with two XPMC-6710 modules into the CompactPCI chassis and
power up.
o Using a terminal emulation application, set port to 115200 baud rate, 8-bit, N0 parity and 1 stop
bit, No flow control.
o
Power on the Chassis.
o
On the computer screen you should see the following message:
•
SPI Interface Established
o
Hitting any key it will take you to this menu:
o
Xembedded Main Menu
•
Port-Based VLAN Configuration
Note: up to four VLANs can be configured on the XCPC-9100.
o
Select 1. You will get this sub menu:
o
0-3) Port-Based VLAN Configuration
ƒ
d) Display VLAN Configuration
ƒ
w) Write configuration to Flash
ƒ
x) Exit to Main Menu
o
Selecting 0 to 3 will let you enter in ports to put with that VLAN. Format
for inputting is port numbers with a space between each number. This is
the list of numbers that correspond to which port:
0 - Front port 0 of XCPC-9100
1 - Front port 1 of XCPC-9100
2 – PMC site 1 port eth0
3 – PMC site 1 port eth1
4 – PMC site 2 port eth0
5 – PMC site 2 port eth1
6 - To CPCI J3
7 - To CPCI J3
NOTE: To route the Ethernet PMC ports to the on-board Ethernet switch, SW1 to SW8 on the XCPC-
9100 must be set with all odd positions ON and all even positions OFF.
If you don’t assign all ports to a VLAN the unassigned ports go to an unassigned location and are not
routed.
23