Installation Guide XCPC-9100
Switches Settings and Locations
The cPCI-9100 has nine switches on board (SW1 and SW9). The settings on switches one to four
allows the routing of the PMC site two J4 (user defined I/O) to go to either the GbE switch or the
J5 connector of the cPCI. Each of the I/O pins from the PMC is routed to two location on a switch.
For example SW1 Pin 16 and Pin 15 is routed to the PMC Site two J4 Pin2. This allows Pin1 and
Pin2 two of the switch to be routed to the GbE Switch Fabric on board or the rear I/O J5.
Figure 2-2 XCPC-9100 Switch Settings.
9
Содержание XPMC-9100
