GAS FLOW REGULATORS
The job of the gas flow regulator is to reduce the bottle pressure gas down to a lower pressure and deliver it at a constant flow. This
constant flow of gas is usually fed through the welding machine where it is controlled by a solenoid valve, operated when the torch
trigger is pulled. Once the gas has passed the solenoid valve it flows down the torch cable exiting at the gas nozzle to protect the weld
pool and surrounding area. There are two main types of flow regulators commonly used for MIG and TIG welding applications. Both
regulator types perform the same function, but have a different way of setting and measuring the gas flow. A flow-gauge regulator (Fig.1)
has a dial-type pressure gauge to measure the cylinder contents and a second gauge to measure and deliver the flow rate required.The
flow-meter regulator (Fig.2) has a pressure gauge to measure the cylinder contents and a flow tube assembly to measure and deliver
the flow rate required. Some flowmeter regulators will have two flow tube assemblies (Fig.3) typically one is used for supplying gas to
the welding machine and the other is used used for purging the welding area with gas prior to welding, during welding and post welding
and at a separate rate of flow from that being supplied to the welding machine. The amount of gas flow needed to do the job will depend
on the welding gas and the job being done, but a common setting to start with is 10 L/min.
SHIELDING GASES
Shielding gases are almost always necessary for MIG and TIG welding processes to protect the weld zone from gases that are contained
in the surrounding atmosphere, particularly nitrogen and oxygen. If allowed into the weld zone these gases will contaminate the weld
pool resulting in fusion defects also porosity and embrittlement of the weld metal. Selecting the right type of shielding gas depends on
the welding process being used and type of material being welded. The MIG process is typically a mixture of Argon and Co2 (AR90%
Co2 10%) or pure Co2 for steel welding applications, other specialised mixtures of Argon, Co2, and Oxygen are available for stainless
steel welding but with welding aluminium pure Argon is almost always used The TIG welding process almost always requires 100%
Argon for welding of all materials, however in some specialised applications Helium, or a Helium mix are sometimes used. Today with
the multitude of gas mixes available through a number of different suppliers, it is difficult to list and recommend which gas mix is better
for which job. If you are unsure about what gas or gas mix to use we recommend you discuss with your application local gas suppliers
or your Esseti technical representative.
GAS FLOW RATES
For MIG applications the ideal gas flow rate will depend on the type of mig wire, wire feed speed and current being used and also the type
metal transfer mode, i.e. Dip Transfer, Spray. Pulse Mig. Long interconnecting cables between the power source and wire feeder and also
long push pull torch cables may require higher flow rates to compensate for the distance. As a general rule of thumb;
1. Small weld pools use 10 L/min,
2. Medium weld pools up to 15 L/min
3. Large spray, pulse mig weld pools use up to 25 L/min.
It is important to note that too high gas flow can be just as bad as having too low flow rate. The reason being that if the gas flow exits
the gas nozzle a too high rate it can.
1. create a vortex and draw air into the gas flow and the weld zone causing contamination of the weld.
2. produce turbulence at the weld pool resulting in a poor quality weld.
Fig.1
Fig.2
Fig.3
42
|
RAZORWELD™ 205SS MIG/TIG/STICK Welder Manual
GAS FLOW REGULATORS - SHEILDING GASES
GAS FLOW RATES
