20
|
RAZORWELD™ 205SS MIG/TIG/STICK Welder Manual
TORCH & WIRE FEED SET UP FOR
ALUMINIUM WIRE
(11) Install a U groove drive roller of the
correct size for the diameter wire being
used.
(17) Fit the remaining front end parts to the
torch neck ready for welding.
Continued...
(10) Loosen off the inlet guide tube retaining screw
(11) Remove the inlet guide tube from the front end machine euro connector using long nose pliers.
(12)
Carefully feed the extended PA liner section into the inlet guide tube hole of the machine euro
connector
(13)
Feed the extended PA liner all the way up and over the drive roller
(14) Tighten the torch euro connection to the machine euro connector
(15)
Cut the extended liner with a sharp Stanley knife just in front of the drive roller
(16) Fit an Aluminium contact tip of the correct size to match the diameter of the wire being used
(17) Fit the remaining front end parts to the torch neck ready for welding
(16) Fit an Aluminium contact tip of the
correct size to match the wire diameter
being used
(10) Connect the torch to the machine tight-
en and secure the torch euro connector to
the machine euro connection.
(7) Place aluminium wire onto spool hold-
er. Feed the wire through the inlet guide
tube on to the drive roller.
(12) Press and hold the inch wire button to
feed the wire down the torch cable through
to the torch head.
