X5368r-P3
User’s Manual Version 1.0
9
VIII. Default Values
X5368r-P3
is pre-configured with the following parameters; you may
also re-load the default parameters by pressing the reset button of
the modem for about 10 seconds or by using the
System
Commands
link in the Web interface.
Note:
The Username and Password are case-sensitive.
Username/Password
: admin
Default IP Address
WAN and ADSL
Ethernet (local) IP: 192.168.1.1
Local Line Code: Multi Mode
Subnet mask: 255.255.255.0
DHCP Server:
Disable
Protocol
DHCP start IP: 192.168.1.1
RFC1483 Bridge: VPI/VCI: 8/35
DHCP end IP: 192.168.1.254
Class (QoS): UBR
DNS
Relay:
Disabled
VoIP
Codec:
G.711
Protocol:
SIP
SIP
Proxy:
192.168.1.1
End point 1 name: 0001
End point 2 name: 0002
SIP reg/ proxy port: 5060
Expire
Time:
3600
SIP Send Transport: UDP
X5368r-P3
User’s Manual Version 1.0
10
IX. Software Upgrade
You may easily upgrade
X5368r-P3
embedded software by obtaining
the compressed upgrade kit from the service provider and then
following the steps for upgrading through either a DOS prompt or a
Web-browser:
Software Upgrade through a DOS Prompt
Step 1:
Extract the ZIP file for updated firmware.
Step 2:
Connect
X5368r-P3
via the local Ethernet port or remote
ADSL link, making sure that the
X5368r-P3
Ethernet IP
address and your terminal are properly configured so that
you can successfully “
ping
”
X5368r-P3
The default local IP
address is “192.168.1.1”.
Step 3:
Under the DOS prompt, execute the command “xupgrade
<
IP address of
X5368r-P3
, for instance, “xupgrade
192.168.1.1”.
Step 4:
This upgrading process may last as long as 60 seconds.
Step 5:
Reboot
X5368r-P3
with new software.
Note
: Strictly maintain stable power to
X5368r-P3
while upgrading its
software. If the power fails during the upgrading process, contents in the
memory could be destroyed, and the system may hang. In such a
case, you must call the dealer or system integrator for repairs.
